Never connect the red cable to the negative battery terminal or a vehicle with a dead battery. Identify a metal ground within the vehicle with the dead battery. You can use the metal frame of the vehicle. Connect the other negative clamp to the metal ground of the vehicle with the dead battery.
You can use the engine block or another metal surface of the vehicle away from the battery. This is the last connection you need to make. Start the car with the charged battery.
If you have an electric or hybrid car, follow directions in the owners manual. Degree of difficulty: Medium. Tools required: A portable battery starter streamlines the process. Otherwise, battery cables, a volunteer car with a working battery, goggles. Step 1: Pull the assisting car up to the dead car close enough so the cables can reach but not so close that the cars touch.
Turn off headlights, blinkers, radios and heating systems, and unplug accessories from power sockets on the dead car. Step 2: Pop the hoods. If attempting any repairs yourself, take all safety precautions as necessary. Type: Car Ownership. Published: October 15, Organize the jumper cables First, unravel your jumper cables. Attach the remaining negative cable Back on the other end of the jumper cables, attach the remaining negative battery cable to an unpainted surface away from the battery such as a bolt or an engine bracket.
Charge the dead battery With both cars connected by the jumper cables, start the vehicle with the functioning battery and let it run for a few minutes. Jumpstart your vehicle After letting the battery charge for a few minutes, start the vehicle that initially had a dead battery.
Here is the order: Remove black, remove red, attach red, attach black. Ensure that the connections on both end are secure by trying to move the battery around. Also, what colors go to what when jumping a car? There are also positive and negative cables in the jumper cable set. Never connect the red cable to the negative battery terminal or a vehicle with a dead battery. The safest order to attach the jumper cables is as follows: Attach one red jumper cable clamp to the positive terminal on the dead battery.
Attach the other end of the same cable, the second red jumper cable clamp, to the positive terminal on the working live car battery. Red to Dead - Connect red, or positive, clip to the positive terminal on the battery of the dead car.
Caution: Don't attach the negative cable to the negative terminal of the weak battery when jumping a car battery! This common mistake could ignite hydrogen gas directly over the battery. Battery explosions can cause serious injury. Finally, remove the positive cable from the car with the weak battery. If you connect the negative first , then the positive, if you happen to touch the wrench to something metal while it is touching the positive terminal , that's a short - because the chassis is already connected to the negative battery terminal.
In fact, under normal conditions, a volt car battery will usually not even shock you. The math can get a little complicated, but the main reason that you can safely touch the positive and negative terminals of a typical car battery , and walk away unscathed, has to do with the voltage of the battery. When the jumper cables are incorrectly connected , the polarity of the electrical system on the vehicle with the dead battery will be reversed for a few seconds.
This can irreparably damage many of the sensitive electronic components that are common on today's vehicles, such as on-board computers and electronic sensors. If you 're tempted to test an alternator by disconnecting the negative battery cable , don't do it.
0コメント